10.6 Dialing
Click VoIP > Account 1 (or Account 2) > Dialing to configure dialing timeout
values.
Figure 73 VoIP > Account 1 (or Account 2) > Dialing
The following table describes the labels in this screen.
Table 55 VoIP > Account 1 (or Account 2) > Dialing
LABEL
Inter-digit
Timeout
First-digit
Timeout
10.7 Speed Dial
Click VoIP > Account 1 (or Account 2) > Speed Dial to add, edit, or remove
speed-dial rules.
Figure 74 VoIP > Account 1 (or Account 2) > Speed Dial
The following table describes the labels in this screen.
Table 56 VoIP > Account 1 (or Account 2) > Speed Dial
LABEL
Speed Dial Status
Enable
Speed Dial Rules - This is a list of speed dial numbers.
MAX318M2W User's Guide
DESCRIPTION
Enter the maximum number of seconds (1~5) the WiMAX Device
waits for each digit input of a complete callee number after you press
the flash key on the phone. If the WiMAX Device cannot receive the
next digit entered within this time period, the WiMAX Device
processes digits you have dialed.
Set the number of seconds (5~30) for the WiMAX Device to wait for
you to start dialing a number after you pick up the telephone receiver.
If you do not dial any number within that time period, the dial tone
becomes a busy signal. Put back the receiver and pick it up again if
you want to make a new call.
DESCRIPTION
Select this to enable speed dial on the WiMAX Device.
Chapter 10 The VoIP Account Screens
151