Table of Contents
Advertisement
Manual-2.0-Final_Layout 1 04/04/2016 17:31 Page 32
How to install the Cameras
SAFETY AND INSTALLATION TIPS
Do not attempt to open the units with the power adaptor plug connected to avoid any risk of
personal injury. When installing CCTV camera(s), always follow manufacturer's advice when
using power tools, steps, ladders, etc. and wear suitable protective equipment (e.g. safety
goggles) when drilling holes. Before drilling holes through walls, check for hidden electricity
cables and water pipes. The use of cable/pipe detector is advisable.
Both the Cube and Pan Tilt Cameras are designed for indoor use only, please do not install them
outdoors. The Bullet Camera can be used both indoors and outdoors. To prevent a fire or
electrical shock hazard, do not attempt to open the housing while the unit is exposed to water or
wet conditions. There are no user serviceable parts inside. Refer servicing to qualified service
personnel. Avoid pointing the camera(s) directly at the sun or any moving objects that might
unnecessarily cause the camera to record.
NOTE: You will need to add a micro SD card to enable video recording on the IP Cameras.
Installing the Cube Camera
(1) Secure the camera bracket on a level surface or wall mount using screws provided.
32
(2) Mount the camera onto camera bracket. Adjust the viewing angle and fix the camera tightly.
Advertisement
Table of Contents
Need help?
Do you have a question about the SmartHome Security System and is the answer not in the manual?