Pairing The Pir Sensor - Smart I SmartHome Security System Installation And Operating Instructions Manual

Manual-2.0-Final_Layout 1 04/04/2016 17:31 Page 22
3. Pair the Motion Sensor
(1) Using 'Smart-i Protect', tap
(2) Choose 'Motion Sensor' and
(3A) Auto Pairing Method
Remove the insulating
plastic tab to start the
pairing signal.
22
in the 'Status' section.
to initiate the pairing process.
Select Device
Status
Gi7-351 GO1-D-038
Camera
on Table Room
Siren
Siren PowerSwitch
Remote Key
Hallway Book Room
Door Sensor
Door Sensor PIR
Back Door Lounge
Motion Sensor
Remote Key
Power Switch
Status Scenario Event Setting
Status Scenario
Step 1 of 3
Please tap "Pair" to begin pairing
process
Event Setting Status Scenario Event Setting
(3B) Manual Pairing Method
Press the 'Pairing' button
located inside the battery
compartment.