Pairing The Smoke Detector - Smart I SmartHome Security System Installation And Operating Instructions Manual

Manual-2.0-Final_Layout 1 04/04/2016 17:31 Page 31
9. Pair the Smoke Detector
(1) Using 'Smart-i Protect',
tap in the 'Status' section.
(2) Choose 'Smoke Detector'' and
to initiate the pairing process.
(3) Auto Pairing Method
Insert the batteries supplied to power on the unit and it will
automatically send out pairing signal.
Verifying the Setup
After complete the pairing, press the "test" key on the sensor, the sensor will go off for few
seconds and alert indicator should appear next to the smoke detector section on the status page of
the app.
Status Select Device
Gi7-351 GO1-D-038
Camera
on Table Room
Siren
Siren PowerSwitch
Remote Key Smoke Detector
Hallway Book Room
Door Sensor
Door Sensor PIR
Back Door Lounge
Motion Sensor
Remote Key
Power Switch
Status Scenario Event Setting Status Scenario
Step 1 of 3
Please tap "Pair" to begin pairing
process
Event Setting Status Scenario Event Setting
31