Configuring Ripng Route Redistribution - HP 830 Series Configuration Manual

Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE23:82F5
Dest 1::/64,
via FE80::20F:E2FF:FE23:82F5, cost
Dest 2::/64,
via FE80::20F:E2FF:FE23:82F5, cost
Peer FE80::20F:E2FF:FE00:100
Dest 4::/64,
via FE80::20F:E2FF:FE00:100, cost
Dest 5::/64,
via FE80::20F:E2FF:FE00:100, cost
[SwitchA] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE00:1235
Dest 1::/64,
via FE80::20F:E2FF:FE00:1235, cost
Dest 4::/64,
via FE80::20F:E2FF:FE00:1235, cost
Dest 5::/64,
via FE80::20F:E2FF:FE00:1235, cost

Configuring RIPng route redistribution

Network requirements
Switch B runs two RIPng processes. It communicates with Switch A through RIPng 100 and with
•
Switch C through RIPng 200.
Configure route redistribution on Switch B, allowing the two RIPng processes to redistribute routes
•
from each other. Set the default cost of redistributed routes from RIPng 200 to 3.
Figure 62 Network diagram
Configuration procedure
1. Configure IPv6 addresses for the interfaces. (Details not shown.)
2. Configure RIPng basic functions:
# Enable RIPng 100 on Switch A.
<SwitchA> system-view
on Vlan-interface100
1, tag 0, A, 2 Sec
1, tag 0, A, 2 Sec
on Vlan-interface200
1, tag 0, A, 5 Sec
1, tag 0, A, 5 Sec
on Vlan-interface100
1, tag 0, A, 2 Sec
2, tag 0, A, 2 Sec
2, tag 0, A, 2 Sec
160