Ripng Configuration Examples; Configure Ripng Basic Functions - HP 830 Series Configuration Manual

RIPng configuration examples

Configure RIPng basic functions

Network requirements
As shown in
Switch C, which means the route is not added to the routing table of Switch B, and Switch B does not
forward it to Switch A.
Figure 61 Network diagram
Configuration procedure
1. Configure the IPv6 address for each interface. (Details not shown.)
2. Configure basic RIPng functions:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ripng 1
[SwitchA-ripng-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ripng 1 enable
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 400
[SwitchA-Vlan-interface400] ripng 1 enable
[SwitchA-Vlan-interface400] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] ripng 1
[SwitchB-ripng-1] quit
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] ripng 1 enable
[SwitchB-Vlan-interface200] quit
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ripng 1 enable
[SwitchB-Vlan-interface100] quit
# Configure Switch C.
<SwitchC> system-view
[SwitchC] ripng 1
[SwitchC-ripng-1] quit
[SwitchC] interface vlan-interface 200
[SwitchC-Vlan-interface200] ripng 1 enable
[SwitchC-Vlan-interface200] quit
Figure 61, all switches run RIPng. Configure Switch B to filter the route (3::/64) learned from
158