Self-Defined Option Configuration Example - HP 830 Series Configuration Manual

Poe+ unified wired-wlan switch switching engine
Hide thumbs Also See for 830 Series:
Table of Contents

Advertisement

[SwitchA] dhcp server ip-pool 2
[SwitchA-dhcp-pool-2] network 10.1.1.128 mask 255.255.255.128
[SwitchA-dhcp-pool-2] expired day 5
[SwitchA-dhcp-pool-2] gateway-list 10.1.1.254
Verifying the configuration
After the preceding configuration is complete, clients on networks 10.1.1.0/25 and 10.1.1.128/25 can
obtain correct IP addresses and other network parameters from Switch A. You can use the display dhcp
server ip-in-use command on the DHCP server to view the IP addresses assigned to the clients.

Self-defined option configuration example

Network requirements
As shown in
the DHCP server (Switch A). The IP address belongs to subnet 10.1.1.0/24. The PXE server addresses are
1.2.3.4 and 2.2.2.2.
The DHCP server assigns PXE server addresses to DHCP clients through Option 43, a self-defined option.
The format of Option 43 and that of the PXE server address sub-option are shown in
12, respectively. The value of Option 43 configured on the DHCP server in this example is 80 0B 00 00
02 01 02 03 04 02 02 02 02. The number 80 is the value of the sub-option type. The number 0B is the
value of the sub-option length. The numbers 00 00 are the value of the PXE server type. The number 02
indicates the number of servers. The numbers 01 02 03 04 02 02 02 02 indicate that the PXE server
addresses are 1.2.3.4 and 2.2.2.2.
Figure 22 Network diagram
Configuration procedure
1.
Specify IP addresses for the interfaces. (Details not shown.)
2.
Configure the DHCP server:
# Enable DHCP.
<SwitchA> system-view
[SwitchA] dhcp enable
# Enable the DHCP server on VLAN-interface 2.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] dhcp select server global-pool
[SwitchA-Vlan-interface2] quit
# Configure DHCP address pool 0.
[SwitchA] dhcp server ip-pool 0
[SwitchA-dhcp-pool-0] network 10.1.1.0 mask 255.255.255.0
[SwitchA-dhcp-pool-0] option 43 hex 80 0B 00 00 02 01 02 03 04 02 02 02 02
Figure
22, the DHCP client (Switch B) obtains an IP address and PXE server addresses from
37
Figure 10
and
Figure

Advertisement

Table of Contents
loading

Table of Contents