Verifying The Configuration - HP 830 Series Configuration Manual

Figure 44 Adding a mapping between domain name and IPv6 address
2. Configure the DNS client:
# Enable dynamic domain name resolution.
<Device> system-view
[Device] dns resolve
# Specify the DNS server 2::2.
[Device] dns server ipv6 2::2
# Configure com as the DNS suffix.
[Device] dns domain com

Verifying the configuration

# Use the ping ipv6 host command on the device to verify that the communication between the device
and the host is normal and that the corresponding destination IP address is 1::1.
[Device] ping ipv6 host
Trying DNS resolve, press CTRL_C to break
Trying DNS server (2::2)
PING host.com (1::1):
56 data bytes, press CTRL_C to break
Reply from 1::1
bytes=56 Sequence=1 hop limit=126
Reply from 1::1
time = 2 ms
82