Connecting To A Telephone Line; Turning The Printer On And Off - Xerox workcentre wc3655 User Manual

Installation and Setup
To connect the printer to the computer using a USB cable:
1. Ensure that the printer is turned off.
2. Connect the B end of a standard A/B USB 2.0 cable to the USB Port on the back of the printer.
3. Attach the power cord and then plug in the printer and turn it on.
4. Connect the A end of the USB cable to the USB Port on the computer.
5. When the Windows Found New Hardware Wizard appears, cancel it.
You are ready to install the print drivers. For details, see Installing the Software.

Connecting to a Telephone Line

Note: Not all options listed are supported on all printers. Some options apply only to a specific
printer model, configuration, operating system, or driver type.
1. Ensure that the printer is turned off.
2. Connect a standard RJ11 cable, No. 26 American Wire Gauge (AWG) or larger, to the Line port on
the back of the printer.
3. Connect the other end of the RJ11 cable to an operating telephone line.
4. Enable and configure the Fax functions.
For details, see the System Administrator Guide at www.xerox.com/office/WC3655docs.

Turning the Printer On and Off

This printer has both a power switch and a power button. The power switch on the side of the printer
controls the main power to the printer. The control panel power button controls power to the printer
electronic components. The preferred software-controlled printer shutdown method is to press the power
button.
To turn on the printer:
• Turn on the power switch.
• If the power switch is on, but the printer is powered off, the printer was turned off using the power
button. To turn on the printer, on the control panel, press Power.
To turn off the printer:
34 Xerox® WorkCentre® 3655 Multifunction Printer
User Guide