Copy And Scan Problems - Xerox workcentre wc3655 User Manual

Table of Contents

Advertisement

Troubleshooting
Symptom
The printed surface of the paper is
bumpy.

Copy and Scan Problems

If the copy or scan quality is poor, refer to the following table.
Symptoms
Lines or streaks present in copies only made
from the document feeder.
Spots present in copies taken from the
document glass.
The reverse side of the original is showing on
the copy or scan.
Image is too light or too dark.
If the problem persists, for online support information, go to www.xerox.com/office/WC3655support.
172
Xerox® WorkCentre® 3655 Multifunction Printer
User Guide
Solutions
1. Print a solid image over the entire surface of one sheet of paper.
2. Load the printed sheet into the tray with the printed side face down.
3. Print five blank pages to remove debris from the fuser rollers.
Solutions
There is debris on the document glass. When scanning, the paper
from the document feeder passes over the debris creating lines or
streaks. Clean all glass surfaces with a lint-free cloth.
There is debris on the document glass. When scanning, the debris
creates a spot on the image. Clean all glass surfaces with a lint-free
cloth.
Turn on Background Suppression.
• Copy: To lighten, darken, or adjust contrast, use the Image
Quality settings.
• Scan: To lighten, darken, or adjust contrast, use the Advanced
Settings Tab.

Advertisement

Table of Contents
loading

Table of Contents