Operations; Initialisation; Passcodes - Adam Equipment pgw series User Manual

9.0 OPERATIONS

9.1

INITIALISATION

If an operator passcode has been set, the display will show "PASSCODE" and
the main display will show a zero. In this case you must enter the passcode
to continue using the numeric entry method (see section 7.1). A different
passcode may be set for a Supervisor to weigh or to have access to the
selected User menus.
continue as below.
9.2

PASSCODES

If a passcode has been set to limit access to the weighing functions of the
balance the display will show "PASSCODES" with the main digit set to zero.
Use the numeric entry method (see section 7.1) to enter the code. The
display will change to show 7 digits set to zero with the rightmost digit
flashing. Make sure to enter the correct passcode to continue.
Section 13.6 for details.
© Adam Equipment Company 2007
When the balance is first switched on, it
will display the balance serial number (if
set), software revision, model capacity
and then all segments on the display will
be shown.
usually 5 -10 seconds.
If the passcode has not been set the balance will
The display will show zero reading along
with the zero symbol "
weighing unit last used.
time calibration is enabled the balance
will calibrate 15 minutes after power up
or again after the pre-set time interval.
Page 13 of 48
Overall the time taken is
0
If automatic
and the
"
See the