Basic Operations - Adam Equipment LHS Series Manual

EN

3.3 BASIC OPERATIONS

Power on and off
Press the [ON/OFF] button to turn the scale on or off. The display on the scale
will show the model capacity then countdown from 9 to 0 before displaying zero
weight.
Zero the scale
Press the [Zero] key so that the display shows zero.
Change the weighing Unit
Press the [Unit] key to change the weighing unit
C O P Y
Standard Hold (setting 1)
When the reading may not be perfectly stable or you cannot view a reading
easily you can press the [Hold] key to lock it. The reading will be locked and also
flash at the point you press the [Hold] button enabling you to view it when you
can. The Hold LED will also light up and once you have noted the reading a press
of the [Hold] key will return the scale to the normal weighing mode.
Peak Hold (setting 0)
Peak Hold is the highest weight reading registered by the scale when a weighing
takes place. Press the [Hold] key when the display is at zero and the Hold LED
will flash which denotes Peak Hold has been activated. When weight/force is
applied to the scale the display will also flash and lock the highest recorded
weight of that weighing process. This value and the Hold LED will remain flashing
on the display until the [Hold] key is pressed again at which point the scale will
return to normal weighing mode displaying the current weight on the scale.
Press [Hold] again to perform another Peak Hold weighing at any time.
© Adam Equipment Company 2012
8 700660200RevB-Nov2012