Operations; Initialisation; Passcodes; Weighing - Adam Equipment Eclipse EBL Series Operating Manual

EN
10

OPERATIONS

10.1 INITIALISATION

If Operator and Supervisor passcodes have been set, the display will show "
this case you must enter the passcode to continue, using the numeric entry method (see
section Error! No bookmark name given.). If passcode is incorrectly entered then the
ERROR ER ROR
ER ER ROR ROR
message " CODE" will flash, shortly followed by "0 0 0 0 ". Once a passcode is correctly CODE
CODE CODE
entered, or if passcodes have not been set, the balance will continue as below.

10.2 PASSCODES

This equipment has passcode security functions which can restrict certain operations to
particular users. Supervisor and Operator modes are available. If no passcode is set then
the default access is Supervisor level. Setting a Supervisor passcode gives the option to
lock down key parameters so that they are not available to be changed by operator-level
staff.
If a passcode has been set to limit access to the weighing functions of the balance then
when reset or turned on, or when the [Select] key is pressed in Operator mode, the
PASSCODE PASSCODE PASSCODE PASSCODE
display will show "
8.1.) to enter either the operator or supervisor code depending on the access level
required. The display show the digits entered as they are set. The active digit will have the
"-" symbol flashing. Make sure to enter the correct passcode to continue. See Section
13.7. for details.

10.3 WEIGHING

Press [ 0/T] to zero the balance if required. The "
Carefully place a mass on the pan and the weight will be displayed with the
on the left hand side of the display to indicate that a stable reading has been obtained.
If a container is to be used, place it on the balance and press [
When the balance symbol
balance is tared.
© Adam Equipment Company 2015
When the balance is first switched on, it will
display the balance serial number, the software
revision, the model capacity and then all
segments on the display will be shown.
Overall the time taken is usually 5 -10
seconds.
The display will show zero reading along with
the zero symbol "
last used. If automatic time calibration is
enabled the balance will calibrate 15 minutes
after power up, or again after the pre-set time
interval.
0 0 0 0" followed by "0 0 0 0 ". Use the numeric entry method (see section
Net
is on, the " " symbol will be displayed to indicate that the
0" and the weighing unit
0 
" symbol will be displayed.
0/T] to tare the weight.
18
3016612482 Rev1-Aug15
PASSC C C C O O O O D D D D E E E E PASS PASS PASS
0 0 0 0". In
symbol