Operations; Initialisation; Passcodes - Adam Equipment NBL 84 e/i Operating Manual

EN

10 OPERATIONS

10.1 INITIALISATION

If Operator and Supervisor passcodes have been set, the display will show "PASS CD
shortly followed by "0 0 0 0 ". In this case you must enter the passcode to continue, using the
numeric entry method (see section Error! Reference source not found.). If passcode is
incorrectly entered then the message "ER CODE
passcode is correctly entered, or if passcodes have not been set, the balance will
continue as below.

10.2 PASSCODES

This equipment has passcode security functions which can restrict certain operations to
particular users. Supervisor and Operator modes are available. If no passcode is set then
the default access is Supervisor level. Setting a Supervisor passcode gives the option to
lock down key parameters so that they are not available to be changed by operator-level
staff.
If a passcode has been set to limit access to the weighing functions of the balance then
when reset or turned on, or when the [Setup] key is pressed in Operator mode, the display
will show "PASS CD PASS CD" followed by "0 0 0 0 ". Use the numeric entry method (see section 8.1) to PASS CD PASS CD
enter either the operator or supervisor code depending on the access level required. The
display show the digits entered as they are set. The active digit will have the "-" symbol
flashing. Make sure to enter the correct passcode to continue. See Section 13.7 for
details.
© Adam Equipment Company 2015
When the balance is first switched on, it will
display the balance serial number, the software
revision, the model capacity and then all
segments on the display will be shown.
Overall the time taken is usually 5 -10
seconds.
ER CODE" will flash, shortly followed by "0 0 0 0 ". Once a ER CODE ER CODE
The display will show zero reading along with
the zero symbol "
last used. If automatic time calibration is
enabled the balance will calibrate 15 minutes
after power up, or again after the pre-set time
interval.
18
PASS CD", PASS CD PASS CD
0" and the weighing unit
3016612481Rev2.00-Jul15