BASIC OPERATIONS
Power on and off
Press the [ON/OFF] button to turn the scale on or off. The display on the scale will show the
model capacity then countdown from 9 to 0 before displaying zero weight.
Zero the scale
Press the [Zero] key so that the display shows zero.
Change the weighing Unit
Press the [Unit] key to change the weighing unit
Standard Hold (setting 1)
When the reading may not be perfectly stable or you cannot view a reading easily you can press
the [Hold] key to lock it. The reading will be locked and also flash at the point you press the
[Hold] button enabling you to view it when you can. The Hold LED will also light up and once
you have noted the reading a press of the [Hold] key will return the scale to the normal weighing
mode.
Peak Hold (setting 0)
Peak Hold is the highest weight reading registered by the scale when a weighing takes place.
Press the [Hold] key when the display is at zero and the Hold LED will flash which denotes Peak
Hold has been activated. When weight/force is applied to the scale the display will also flash
and lock the highest recorded weight of that weighing process. This value and the Hold LED will
remain flashing on the display until the [Hold] key is pressed again at which point the scale will
return to normal weighing mode displaying the current weight on the scale.
Press [Hold] again to perform another Peak Hold weighing at any time.
© Adam Equipment Company 2017
7