Effecta Komplett III Owner's Manual page 20

A complete pellet boiler
Hide thumbs Also See for Komplett III:
Table of Contents

Advertisement

Menu system
Information
Number starts
Igniter hours
Oper. pellets
Clean number
Reset info
Service
Clean at
On
Off
Interval
Number clean
Clean pause
Flue gas
Max time burner
Extern control
Installation
Advanced
Fill feeder
Effect high speed
Effect low speed
Testblow start
Phase out
Fan pre oper.
Fan low pre oper.
Clean phase out
Flame sens
Quick start
Flame sensor
Level start
Level oper
Time oper
Time phase out
Quick start
Temp down - °C
Temp down - min
20
Effecta AB Västra Rågdalsvägen 21 434 99 Kungsbacka Sweden +46-300 - 22320 info@effecta.se
Displays the number of burner starts been done
Displays the number of hours ignitor has been lit.
Displays the number of hours the burners been running.
Displays the number of times the AERO unit has cleaned the burner.
Resets the information above.
Option if cleaning should be done prior to or after the running cycle.
Time when AERO cleaning is allowed (ON).
Time when AERO cleaning is not allowed (OFF).
Choice of how often the AERO cleaning is to be done.
The amount of blows in a cleaning cycle.
Time between each blow in a cleaning cycle.
Temperature when cleaning of the heat exchanger is done
Max operation time of the burner before pause with AERO cleaning.
Choice of external START/STOP control to the boiler. The control could be
done either by NC or NO connection.
>
Seconds the fan blows before ignition phase. Detection of "old" flame.
Seconds the ignitor is active after the flame sensor has approved start value.
The fan speed before operation phase.
Time that the fan afterblows before standby or cleaning.
Menu options for the flame sensor.
Menu options for the quick start function.
Set value where the burner goes from ignition mode to operation mode.
Lowest approved value in operation mode. If lower: "ALARM BURNER"
Time before "ALARM BURNER" when flame sensor lower than level oper.
Time the fan goes to max speed.
Degrees temp shall fall before burner goes to quick start.
The time in which the temp. shall fall before burner activates quick start.

Advertisement

Table of Contents
loading

Table of Contents