Table of Contents
Advertisement
▀
The components
The shunt valve
The shunt valve controls the heat supply from the boiler to the radiator circuit.
Effecta Komplett III is fitted with motorised shunt control. The room temperature can be
adjusted on a scale on the thermostat. An automatic system will significantly reduce fuel usage
and provide a more comfortable environment.
The thermostatic mixer valve
The mixing valve is used to ensure that the temperature of the hot water in your shower and
elsewhere in the house is comfortable. Set the system to the temperature you want by turning
the thermostat between +/-.
The burner
The burner is mounted on the left or right side. The burner heats the water in the boiler which
provides heat to the domestic and hot water.
The turbulators
In the tubes in the heat exchanger hangs the turbulators. The turbulator`s function is to transfer
heat from flue gas to boiler water. They must always be placed in the boiler. If the flue gas
temperature should be to low, the turbulators can be cut off. Always contact the installer before
doing this.
The sealings
The seals on the hatches must be checked every year. If the hatches do not seal properly, the
efficiency and the combustion process of the boiler will deteriorate.
▀
Exploded view, burner
1.
Combustion fan with tachometer
2.
Fan seal
3.
Under pressure switch
4.
Flame sensor
5.
Rear housing
6.
Rear housing seal
7.
Cover for overheating protection
8.
Ignition console
Effecta AB Västra Rågdalsvägen 21 434 99 Kungsbacka Sweden +46-300 - 22320 info@effecta.se
9.
Fall shaft
10
Overheating protection
11
Seal for fall shaft
12
Pellet retarder
13
Inner combustion tube
14
Outer combustion tube
15
Stop plate
7
Advertisement
Table of Contents
