3 Adjust the distance of the calipers using the touchpad.
4 Save the calculation as described in
To measure TAPSE
1 On a frozen M Mode trace, press the CALCS key.
2 From the calculations menu, select the measurement name.
3 Adjust the distance of the calipers using the touchpad.
4 Save the calculation as described in
To calculate MV or AV area
1 On a frozen 2D image, press the CALCS key.
2 In the calculations menu, locate Area, and then select MV or AV.
3 Position the caliper where you want to begin the trace, and press the SELECT key.
4 Using the touchpad, trace the desired area.
a To make a correction, select Undo on-screen or press the backspace key.
5 Complete the trace, and press the SET key.
6 Save the calculation as described in
To calculate Atrial areas and volumes
1 On a frozen 2D image, press the CALCS key.
2 In the calculations menu, locate Atria, and then select the measurement name.
3 Position the caliper where you want to begin the trace, and press the SELECT key.
4 Using the touchpad, trace the desired area.
a To make a correction, select Undo on-screen or press the backspace key.
Note
5 Complete the trace, and press the SET key.
Exam-based calculations
"To save a calculation"
"To save a calculation"
"To save a calculation"
If you start and stop the trace in the same corner, you may not be able to adjust the
vertical length.
on page 74
on page 74
on page 74.
87