FujiFilm SonoSite Edge II User Manual page 75

You can perform a combination of distance, area, circumference, and manual trace measurements at one time.
The total number possible depends on their order and type.
To measure distance (2D)
You can perform up to eight distance measurements on a 2D image.
1 On a frozen 2D image, press the CALIPER key. A set of three calipers appears, connected by a dotted line.
2 Using the touchpad, position the first caliper, and then press the SELECT key. The second caliper becomes
active.
3 Using the touchpad, position the second
the dotted line disappears.
See "To save a measurement to a calculation and patient report"
To measure area or circumference (2D)
1 On a frozen 2D image, press the CALIPER key.
2 Select Ellipse on-screen.
Note
3 Use the touchpad to adjust the size and position of the ellipse. The SELECT key toggles between position
and size. See "To save a measurement to a calculation and patient report"
To trace manually (2D)
1 On a frozen 2D image, press the CALIPER key.
2 Select Manual on-screen.
Note
3 Using the touchpad, position the caliper where you want to begin.
4 Press the SELECT key.
5 Using the touchpad, complete the trace, and press the SET key. See
and patient report" on page 67.
Measurements
caliper.
If you exceed the allowed number of measurements, Ellipse is not available.
If you exceed the allowed number of measurements, Manual is not available.
If you move the calipers close together, they shrink and
on page 67.
"To save a measurement to a calculation
on page 67.
69