FujiFilm SonoSite Edge II User Manual page 147

9 Verify that all gel, debris, and bodily fluids have been removed from the system and transducer. If
necessary, repeat steps 6, 7, and 8 with a new wipe.
WARNING
10 Examine the transducer and cable for damage, such as cracks or splitting where fluid can enter.
If damage is evident, discontinue use of the transducer, and contact FUJIFILM SonoSite or your local
representative.
Part 2 of 2: High-level disinfecting of transducer for semi-critical contact
WARNINGS
Cautions
Table 8-3: Compatible high-level disinfectants for immersing the transducer
Disinfectants Transducer
C11x, HFL38xi, HFL50x,
Cidex HSL25x, ICTx, L25x, L38xi,
P10x, P11x, rC60xi, rP19x
C11x, HFL38xi, HFL50x,
Cidex OPA HSL25x, ICTx, L25x, L38xi,
P10x, P11x, rC60xi, rP19x
For a more complete list, refer to the cleaners and disinfection document available at www.sonosite.com.
Cleaning and disinfecting the system and transducer
Failure to remove all gel, debris, and bodily fluid could leave contaminants on the
transducer.
Be sure to use the appropriate Personal Protective Equipment (PPE) whenever
necessary.
High-level disinfectants can cause harm to the patient if not completely removed
from the transducer. Follow the manufacturer's rinse instructions to remove
chemical residue.
Do not skip any steps or abbreviate the disinfecting process in any way.
Do not use unapproved disinfecting agents.
Do not soak the transducer longer than recommended by the chemical
manufacturer.
Do not immerse the transducer connector in any disinfectant solution.
Use only FUJIFILM SonoSite recommended cleaners and disinfectants. Using a
non- recommended disinfecting solution or incorrect solution strength can
damage or discolor the transducer and void the warranty.
Disinfectant
Temperature
Soak Duration
45 minutes
o o
23 C, 73 F
o o 12 minutes
23 C, 73 F
Clean Water
Soak Time
3 x 1 minute
3 x 1 minute
141