Working With Qemm 50/60 Memory Manager - Kingston Technology KTM609 Installation Manual

Appendix C Troubleshooting
Unrecognized option/command in invocation line.
There is a typographical error in one of the options you added or changed in the
CONFIG.SYS file.
CONFIG.SYS" to make sure your CONFIG.SYS file is correct.
WARNING: Problems encountered in setting default page frame
address.
This message indicates a possible hardware problem. Review the steps you took to
install the SIMMs on the Kingston Memory Expansion Board (See "Installing the
SIMM Modules"), and the steps you took to install the memory board in the computer
(See "Installing the KTM-609/16 Board"). Make sure the SIMMs are installed in the
correct sequence on the memory board, and that all the SIMMs and memory boards
are seated firmly in their sockets. Reboot from your standard DOS diskette or hard
drive.

Working With QEMM 50/60 Memory Manager

In order to use the Quarterdeck QEMM 50/60 Expanded Memory Manager, you must
have QEMM version 6.0 with KTM-609/16 Plus revision C or later.
Note: When using QEMM 50/60, you must configure the KTM-609/16
memory as Extended memory. Refer to "Configuring the System"
section of this manual for details.
KTM-609/16 Installation Guide - Rev. D1
Check the option formats in Appendix B, "Modifying
Kingston Technology Corporation
39