Installing The Memory Expansion Board - Kingston Technology KTM8000/386 Installation Manual

L
L
Installing the Memory Expansion Board
5
Installing the Memory Expansion Board
Once YOU
~lua
the desired number of
SIMM -modules into the KTM-8000/386
memory board and you have created the
Configuration Diskette, you can install the
KTM-8000/386 board into the IBM PS/2
computer. Use the following procedure to
install the KTM-8000/386.
4. Plug the KTM-8000/386 into one of the
32-bii expansion slots. Push the board
down until it seats firmly into the slot.
1. Turn off the PS/2 computer and discon-
nect the AC cord. Unlock the security
lock and disconnect the keyboard and
any peripheral devices.
2. Refer to your IBM user's manual for
detailed instructions on removing the
cover.
3. The KTM-8000/386 must be installed in
a 32-bit expansion slot on the PS/2
motherboard. The 32-bft expansion
slots are longer than other expansion
slots. Figure 4 shows the location of
the expansion slots.
F igure 5:
Installing the KTM-8000/388
5. Reinstall the PSJ2 cover and reconnect
the peripheral components.
The Model 70 has
two expansion slot
locations. Figure 4
shows version E61.
Your locations may
vary, depending on
your version. Figure
4 also shows the
three expansion slot
locations for the
Model 80 (version Ill).
I
PSZ tdO"Fl 70 wER&g f61) Pf:,hlnnFl R"
Figure 4:
32-bit Memory Expansion Slots
Kingston Technology Corporation KTM-8000/386 Installation Guide - REV D