Kingston Technology KTM609 Installation Manual page 42

Appendix C Troubleshooting
Hardware does not support EMS version 4.
This message indicates a possible hardware problem. Review the steps you took to
install the SIMMs on the Kingston Memory Expansion Board (see "Installing the
SIMMs"), and the steps you took to install the memory board in the computer (see
"Installing
KTM-609/16"). Make sure the SIMMs are installed in the correct sequence on the
memory board, and that all the SIMMs and memory boards are seated firmly in their
sockets. Reboot from your standard DOS diskette or hard drive.
Interrupt 67 vector already allocated.
You modified the CONFIG.SYS file to include the Kingston EMS driver. Now, the
Kingston EMS driver is trying to use an interrupt vector already being used by some
other driver. Check the CONFIG.SYS file to make sure no other EMS drivers are
being used. If you find another driver in CONFIG.SYS, remove it, and reboot from
your standard DOS diskette or hard drive.
Invalid hex number or number not divisible by 16.
The EXCLUDE, INCLUDE, and FRAME options in CONFIG.SYS require
hexadecimal arguments. Reboot your computer with the backup Reference diskette,
and check CONFIG.SYS to make sure these options, if present, have hexadecimal
arguments. The allowable values are described in Appendix B, "Modifying
CONFIG.SYS." You may also see this message if the end address is less than the start
address in an EXCLUDE or INCLUDE option.
Invalid page frame address.
The page frame address in the FRAME option in the CONFIG.SYS file must be one of
the following values:
C000, C400, C800, CC00, D000, D400, D800, DC00, or E000
KTM-609/16 Installation Guide - Rev. D1 Kingston Technology Corporation
37
the