Running The Install Program - Kingston Technology KTM609 Installation Manual

Software Installation

Running the INSTALL Program

The Kingston Option diskette includes an INSTALL program which MUST be run to
correctly install the configuration files to your backup Reference diskette. If you run
"Copy an option diskette" from the IBM Reference Menu, it will recognize the KTM-
609 in its system configuration, but will not install the memory correctly.
You must run the INSTALL program from the Kingston Option
diskette to copy the Kingston files to your backup Reference diskette or
the configuration will not complete successfully.
Do NOT use "Copy an option diskette" from the Reference Menu.
Before you start, have both the Kingston Option diskette and your backup copy
Reference diskette ready. This portion of the installation requires the use of DOS. If
you are running OS/2, opening a DOS window will satisfy this requirement. If you
use an operating system that cannot emulate DOS, boot your system from a DOS
diskette.
The following steps show you how to install the option files from the Kingston
diskette to your backup copy Reference diskette.
1. Turn on or reboot your computer (from hard disk or bootable DOS
diskette) and get to the DOS prompt.
2. Remove the boot diskette from drive A, if present, and insert the
Kingston Option diskette. At the prompt, type:
A: [Enter]
3. To start the INSTALL program, type:
INSTALL [Enter]
KTM-609/16 Installation Guide - Rev. D1 Kingston Technology Corporation
7