Kingston Technology KTM609 Installation Manual page 27

22
(C) Copyright 1990, Kingston Technology Corporation
F1 Install Configuration Files onto Reference Disk
F2 Install KEMM.SYS EMS Driver onto a Working Disk.
F3 Change Existing EMS Driver Parameters.
F4 Exit and Back to DOS
3. Press [F3] (Function Key F3) to change the existing EMS driver parameters.
4. The next screen asks you to select the memory segment of Reserved High
Memory where you want to place the paging area. Press the function key that
corresponds to the starting address where you want the paging area to be
located.
(C) Copyright 1990, Kingston Technology Corporation
Install EMS Driver onto a New Drive and Configure
F1 A000 Only if MONOCHROME CARD is installed in your system
F2 B000 Reserved
F3 C000 Reserved
F4 D000 Default Selection
5. Two additional choices now appear on your screen. Refer to the next page.
Kingston Technology Corporation
INSTALLATION Version 1.0
INSTALLATION Version 1.0
KTM-609/16 Installation Guide - Rev. D1
Installing the Kingston EMS Driver