Installing The Ktm-609/16 Board - Kingston Technology KTM609 Installation Manual

12

Installing the KTM-609/16 Board

Now you're ready to install the KTM-609/16 Memory Expansion Board inside your
PS/2 computer. Keep in mind the precautions on static electricity and magnetized
tools. Turn off power to the computer and position it in a convenient, well-lit area. If
this involves moving it very far from its normal location, you will need to unplug its
various terminal and printer cables. Be sure to label them so you can easily reinstall
them when you're done.
STEP 1
•
Turn power off from the computer.
•
Disconnect any cables from the unit.
STEP 2
•
Open the chassis.
•
Choose any available 16-bit expansion slot.
•
Remove the expansion slot bracket.
STEP 3
•
Place the KTM-609/16 into the 16-bit expansion slot.
•
Make sure the board is inserted into the guide channels and properly seated
into the expansion slot.
•
Secure the adapter card to the expansion slot with the thumb screw.
STEP 4
•
Replace the cover and reattach any cables that were disconnected.
The hardware portion of the installation procedure is now complete. You may want to
leave the cover off during the remainder of the installation process in case it becomes
necessary to move the KTM-609/16 for troubleshooting purposes. Now you're ready
for "Configuring the System".
Kingston Technology Corporation
Hardware Installation
KTM-609/16 Installation Guide - Rev. D1