Changing Existing Ems Driver Parameters - Kingston Technology KTM609 Installation Manual

Installing the Kingston EMS Driver
9. Press any key to return to the Installation Menu screen, then press [F4] to
return to the DOS prompt.
10. Now reboot the computer as usual. As the computer reboots, you will see
displayed on the screen the total amount of memory minus any that you
allocated as Expanded memory.
display the amount of Expanded memory.
Now that the Kingston EMS driver is properly installed, you are ready to begin using
your PS/2 computer system to run programs and applications with the additional
memory capacity of the Kingston KTM-609/16 Memory Expansion Board.

Changing Existing EMS Driver Parameters

Any time you want to change the location of the paging area in reserved high memory,
you can rerun the INSTALL program.
1. Make sure your PS/2 is booted from your standard DOS diskette in drive A, or
from the hard disk, drive C.
necessary, and insert the Kingston Option Diskette into drive A, and at the
DOS prompt, type:
A:
and press [Enter].
2. To start the INSTALL program, type:
INSTALL
Now when you press [Enter], the following screen appears:
KTM-609/16 Installation Guide - Rev. D1
When the EMS driver initializes, it will
Remove the boot diskette from drive A, if
Kingston Technology Corporation
21