Installing The Kingston Ems Driver - Kingston Technology KTM609 Installation Manual

Installing the Kingston EMS Driver

Installing the Kingston EMS Driver
You only need to perform the instructions in this section if you allocated some or all of
the new memory as Expanded.
The Kingston EMS driver you are about to install is the program that manages the
paging of 16KB segments of memory into and out of the 64KB page frame located in
reserved high memory.
1. Make sure your PS/2 is booted from your standard DOS diskette in drive A, or
from the hard disk, drive C.
necessary, and insert the Kingston Option Diskette into drive A. At the DOS
prompt, type:
A:
and press [Enter].
2. To start the INSTALL program, type:
INSTALL
Now when you press [Enter], the following screen appears:
(C) Copyright 1990, Kingston Technology Corporation
F1 Install Configuration Files onto Reference Disk
F2 Install KEMM.SYS EMS Driver onto a Working Disk.
F3 Change Existing EMS Driver Parameters.
F4 Exit and Back to DOS
KTM-609/16 Installation Guide - Rev. D1
Remove the boot diskette from drive A, if
INSTALLATION Version 1.0
Kingston Technology Corporation
17