Kingston Technology KTM609 Installation Manual page 28

Installing the Kingston EMS Driver
(C) Copyright 1990, Kingston Technology Corporation
Install EMS Driver onto a New Drive and Configure
F1 A000 Only if MONOCHROME CARD is installed in your system
F2 B000 Reserved
F3 C000 Reserved
F4 D000 Default Selection
F1 YES if you would like to update the config.sys file
F2 NO if you do not want to update the config.sys file
• If you want to proceed, press [F1] to update the CONFIG.SYS file.
• If you think you missed a step and need to do this procedure over again,
press [F2] to bypass updating the CONFIG.SYS file.
6. Press any key to return to the Installation Menu screen, then press [F4] to
return to the DOS prompt.
7. Now reboot the computer as usual. If the paging area has been successfully
relocated, there will be no visible indication. Your system should operate as
usual.
KTM-609/16 Installation Guide - Rev. D1
INSTALLATION Version 1.0
Kingston Technology Corporation
23