Kingston Technology KTM609 Installation Manual page 24

Installing the Kingston EMS Driver
6. If your computer boots from a floppy diskette, remove the Kingston Option
Diskette from drive A, and insert your standard DOS boot diskette. Press any
key to continue.
(C) Copyright 1990, Kingston Technology Corporation
Install EMS Driver onto a New Drive and Configure
Insert Kingston Option Diskette into Drive A:
The INSTALL program now copies the EMS driver from the computer's
memory onto the disk you specified as your boot device.
7. The next screen asks you to select the memory segment of Reserved High
Memory where you want to place the paging area. We recommend that you
choose the default selection, D000, by pressing [F4].
Note: The memory segment map requires 64KB of contiguous memory
starting at location D000 (DEFAULT).
D000-DFFF cannot be occupied by any other adapters. Therefore, if
any other adapters occupy any portion of this space, they must be
relocated via the IBM Setup Program.
The KTM-609/16 memory segment map can also be relocated as
described below.
KTM-609/16 Installation Guide - Rev. D1
INSTALLATION Version 1.0
Press Any Key to Continue
This means that segments
Kingston Technology Corporation
19