Changing The Amount Of Expanded Memory - Kingston Technology KTM609 Installation Manual

Changing the System Configuration
6. On the Change Configuration screen, move the cursor to the number of the slot
where the KTM-609/16 board is located, and use the [F5] and [F6] functions
keys to specify the amount of memory you want to allocate as Expanded
(paged) memory. The remaining memory, if any, is automatically allocated as
Extended.
7. Press [F10] followed by an [Enter] to save the configuration.
8. Press the exit key ([ESC] or [F3] depending on version) to exit from the Set
Configuration Screen.
9. Press the exit key again to return to your system prompt.
10. Remove the backup Reference diskette from drive A.
11. You are now ready to reboot with the newly configured memory.
12. As the system boots, you will see the total amount of memory minus the
amount allocated as Expanded displayed on the screen. When the EMS driver
initializes, it will display the amount of memory allocated as Expanded
memory.

Changing the Amount of Expanded Memory

1. Insert the backup Reference diskette into drive A.
2. Reboot the computer.
NOTE: No error occurs during boot-up, and therefore, auto-configure is not
asked for.
3. When the Set Configuration menu appears, select Change Configuration, and
press [Enter].
KTM-609/16 Installation Guide - Rev. D1 Kingston Technology Corporation
25