Section 7 Troubleshooting Guide - Taylor C819 Operating Instructions Manual

Section 7
PROBLEM
1. One side of the grill will not
heat. The control will display
the message, "FAULTY
ELEMENT OR SHORTED
PROBE" after the TOO COOL
timer has elapsed.
2. One heat zone will not heat.
(Display reads "TOO COOL".)
3. One of the heat zones is
overheating. (Display reads
"TOO HOT".)
4. The grill will not turn on when
power switch is placed in the
ON position.
5. The upper platen will not stay
in the STANDBY mode, but will
stay in the COOK position.
Models C819 & C821
Troubleshooting Guide
PROBABLE CAUSE
a. The heater is faulty.
b. The high limit switch is faulty.
c. The solid state relay is faulty.
a. The interface board is faulty.
b. The solid state relay is faulty.
c. The control harness is faulty.
a. The interface board is faulty.
b. The solid state relay is faulty.
a. The restaurant circuit breaker
has been tripped.
b. The control cord is not
connected properly.
c. The fuse in the control box is
faulty.
d. The power switch is faulty.
a. Incorrect use of the STANDBY
button.
b. Faulty wire connections.
31
REMEDY
a. Call a service technician.
b. Call a service technician.
c. Call a service technician.
a. Call a service technician.
b. Call a service technician.
c. Call a service technician.
a. Call a service technician.
b. Call a service technician.
a. Reset the circuit breaker.
b. Reconnect the cord.
c. Call a service technician.
d. Call a service technician.
a. Press the STANDBY button
within five seconds of lowering
the platen into the COOK
position.
b. Call a service technician.
Troubleshooting Guide