Taylor C819 Operating Instructions Manual page 17

The release material must be replaced when:
S
Cleaning procedures fail to remove all
buildup and product sticks to the release
material.
S
A tear appears in the cooking area of the
release material, causing product to stick to
the release material.
Figure 10
Note: It is not necessary to change the release
material if small pin holes develop on the sheet.
CAUTION: The upper platen surface and
release material are very hot. To prevent burn
injuries, wear heat-resistant gloves when
replacing release material.
Models C819 & C821
Care of Release Material Sheets
DO NOT:
S
DO NOT fold or crease.
S
DO NOT touch with sharp objects, grill
scrapers, or abrasive pads.
S
DO NOT place under other equipment or
objects.
S
DO NOT hot-hose or soak in water.
DO:
S
DO clean with a squeegee after each run of
product.
S
DO wipe with a clean, sanitizer-soaked grill
cloth a minimum of 4 times per hour and
more often during peak periods.
S
DO clean daily on both sides, using an
approved high temperature grill cleaner and
the grill cleaning pad and holder identified on
page 9.
13
Figure 11
110602
Operating Procedures