Section 7 Troubleshooting Guide - Taylor QS10 Operating Instructions Manual

Section 7
PROBLEM
1. Grill will not heat.
2. One heat zone will not heat.
(Indicator light is not on,
display flashing "TOO COOL".)
3. One heat zone will not heat.
(Indicator light is on, display
flashing "TOO COOL".)
4. One heat zone is overheating.
(Display flashing "TOO HOT".)
5. Upper cook surface will not
stay in the raised position.
Troubleshooting Guide
Troubleshooting Guide
PROBABLE CAUSE
a. Power cord is not connected.
b. Circuit breaker is tripped.
c. Power switch is in the OFF
position.
d. Power switch is faulty.
e. Faulty relay or relay board.
a. Control is not set correctly.
b. Faulty relay or relay board.
c. Unit displays a fault.
d. Faulty thermocouple.
a. Heater is faulty.
b. Thermocouple is faulty.
c. Thermo overload is faulty.
d. Faulty relay or relay board.
e. Unit displays a fault.
a. Thermocouple is faulty.
b. Faulty relay or relay board.
c. Unit displays a fault.
a. Defective gas filled cylinder(s).
24
REMEDY
a. Check the power connection.
b. Reset the circuit breaker.
c. Place the power switch in the
ON position.
d. Contact a service technician.
e. Contact a service technician
a. Check the temperature setting.
b. Contact a service technician.
c. Clear the fault. (See page 12.)
If the action is ineffective,
contact a service technician.
d. Contact a service technician.
a. Contact a service technician.
b. Contact a service technician.
c. Contact a service technician.
d. Contact a service technician.
e. Clear the fault. If the action is
ineffective, contact a service
technician.
a. Contact a service technician.
b. Contact a service technician
c. Clear the fault. (See page 12.)
If the action is ineffective,
contact a service technician.
a. Contact a service technician.
Models QS10 & QS22