Taylor C819 Operating Instructions Manual page 16

Step 3
Hold the non-hemmed end of the release material
sheet. Gently pull the sheet tight, wrapping it around
the platen in a side-to-side manner.
Figure 7
Note: Check the alignment of the release material
sheet and make sure it fits smoothly over the upper
platen.
Step 4
Place the release material clips over the release
material sheet. Press them into place over the
release material bar at the top of the platen.
Figure 8
Operating Procedures
Step 5
Check the tightness of the release material sheet
against the upper platen.
Note: Installing the release material sheets too
tightly may cause premature failure of the sheet.
Step 6
Repeat steps 1 through 5 for the remaining upper
platen.
Note: Temperature checks should only be
conducted with the release material sheets removed.
12
Figure 9
Models C819 & C821