Completing The Test; Overfrequency Protection Saptof; Verifying The Settings - ABB RET670 Installation And Commissioning Manual

1MRK 504 088-UEN C
13.8.1.2
13.8.2
13.8.2.1
Installation and commissioning manual
1. Check that the IED settings are appropriate, especially the START value and
the definite time delay.
2. Supply the IED with three-phase voltages at their rated values.
3. Slowly decrease the frequency of the applied voltage, until the START signal
appears.
4. Note the operate value and compare it with the set value.
5. Increase the frequency until rated operating levels are reached.
6. Check that the START signal resets.
7. Instantaneously decrease the frequency of the applied voltage to a value about
20% lower than the operate value.
8. Measure the time delay of the TRIP signal, and compare it with the set value.
Extended testing
1. The test above can be repeated to check the time to reset.
2. The tests above can be repeated to test the voltage dependent inverse time
characteristic.
Verification of the low voltage magnitude blocking
1. Check that the IED settings are appropriate, especially the StartFrequency,
IntBlockLevel, and the TimeDlyOperate.
2. Supply the IED with three-phase voltages at rated values.
3. Slowly decrease the magnitude of the applied voltage, until the BLKDMAGN
signal appears.
4. Note the voltage magnitude value and compare it with the set value
IntBlockLevel.
5. Slowly decrease the frequency of the applied voltage, to a value below
StartFrequency.
6. Check that the START signal does not appear.
7. Wait for a time corresponding to TimeDlyOperate, and make sure that the
TRIP signal not appears.

Completing the test

Continue to test another function or end the test by changing the Test mode setting
to Off. Restore connections and settings to their original values, if they were
changed for testing purposes.

Overfrequency protection SAPTOF

Prepare the IED for verification of settings as outlined in section
section "Preparing for test"

Verifying the settings

Verifying settings by secondary injection
in this chapter.
Section 13
"Overview" and
165