ABB RET670 Installation And Commissioning Manual page 67

1MRK 504 088-UEN C
Installation and commissioning manual
connector receptacle and the fastening screw shall be tightened with a torque
of 0.4 Nm (This torque applies to all binary connectors).
2. Plug the connector to the corresponding back-side mounted male connector
3. Lock the connector by fastening the lock screws
IEC02000742 V1 EN
Figure 31: A female connector
IEC04000167 V1 EN
Figure 32: Board with male connectors
Section 5
Installing the IED
xx02000742.vsd
61