Intended Audience; Related Documents - ABB RET670 Installation And Commissioning Manual

1MRK 504 088-UEN C
1.1.3
1.1.4
Documents related to RET670
Operator's manual
Installation and commissioning manual
Technical reference manual
Application manual
Buyer's guide
Sample specification
Connection diagram, Two winding transf. Single breaker arrangements
Connection diagram, Two winding transf. Multi breaker arrangements
Connection diagram, Three winding transf. Single breaker arrangements
Connection diagram, Three winding transf. Multi breaker arrangements
Configuration diagram A, Two winding transf. with single or double busbar but with a single breaker arr. on
both sides (A30)
Configuration diagram B, Two winding transf. in multi breaker arr. on one or both sides (A40)
Configuration diagram C, Three winding transf. with single or double busbar but with a single breaker arr. on
both sides (B30)
Configuration diagram D, Three winding transf. in multi breaker arr. on one or both sides (B40)
Configuration diagram E, Two or three winding transf., back-up protection package (A10)
Configuration diagram F. Tap changer control package for two parallel transformers. (A25)
Table continues on next page
Installation and commissioning manual
• The chapter Verifying settings by secondary injection
how to verify that each included function operates correctly according to the
set values.
• The chapter Commissioning and maintenance of the fault clearing system
discusses maintenance tests and other periodic maintenance measures.
• The chapter Fault tracing and repair
• The chapter Glossary
ABB technical documentation.

Intended audience

General
The installation and commissioning manual addresses the personnel responsible for
the installation, commissioning, maintenance and taking the protection in and out
of normal service.
Requirements
The installation and commissioning personnel must have a basic knowledge in
handling electronic equipment. The commissioning and maintenance personnel
must be well experienced in using protection equipment, test equipment, protection
functions and the configured functional logics in the protection.

Related documents

explains how to troubleshoot.
is a list of terms, acronyms and abbreviations used in
Section 1
Introduction
contains instructions on
Identity number
1MRK 504 087-UEN
1MRK 504 088-UEN
1MRK 504 086-UEN
1MRK 504 089-UEN
1MRK 504 091-BEN
SA2005-001283
1MRK 002 801-LA
1MRK 002 801-HA
1MRK 002 801-KA
1MRK 002 801-GA
1MRK 004 500-93
1MRK 004 500-94
1MRK 004 500-95
1MRK 004 500-96
1MRK 004 500-135
1MRK 004 500-140
13