Table of Contents
Advertisement
SwitchX 40GigE 1U Ethernet Switch Installation Guide
Appendix A: Transferring the Power Cord
To use the rail kit to transfer the power cord from the connector side to the power side follow these
directions. Do you want to install power cords on both sides of the switch or only one side? For
each power cord you want to transfer:
1.
Once you have decided which side of the switch will be next to the vertical support?
2.
Make sure that you place the cord so that the correct end of the cord will be at the power side
of the switch. This will depend on which of the four mounting options you choose.
3.
Put the power cord in the switch slide channel.
4.
Screw the switch slides to the switch.
Figure 11: Transfer Power Cord
Mellanox Technologies
Rev 1.4
25
Advertisement
Table of Contents
