Mellanox Technologies switchx MSX1035B-1BRR Installation Manual page 18

Rev 1.4
Table 4 - Serial Terminal Program Configuration (Continued)
Parameter
Flow Control
Login (from a serial terminal program) as admin and use admin as password. This starts the
Step 3.
Mellanox configuration wizard.
Go through the Mellanox configuration wizard. Table 5 shows an example of a wizard session.
Step 4.
Table 5 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 1 of 2)
Wizard Session Display (Example)
Mellanox configuration wizard
Do you want to use the wizard for initial configura-
tion? yes
Step1: Hostname? [switch-1]
Step 2: Use DHCP on mgmt0 interface? [no]
Step 3: Enable IPv6? [yes] yes
Step 4: Enable IPv6 autoconfig (SLAAC) on mgmt0
interface? [no] no
18 Mellanox Technologies
Setting
None
You must perform this configuration the first time you
operate the switch or after resetting the switch. Type
'y' and then press <Enter>.
If you wish to accept the default hostname, then press
<Enter>. Otherwise, type a different hostname and
press <Enter>.
Perform this step to obtain an IP address for the switch.
(eth0 is the management port of the switch.)
If you wish the DHCP server to assign the IP address,
type 'yes' and press <Enter>.
If you type 'no' (no DHCP), then you will be asked
whether you wish to use the 'zeroconf' configuration
or not. If you enter 'yes' (yes Zeroconf), the session
will continue as shown in Table 6.
If you enter 'no' (no Zeroconf), then you need to enter
a static IP, and the session will continue as shown in
Table 7.
The management interface will be able to use IPv6
addresses.
This turns on autoconfiguration of the IPv6 addresses.
This is unsuitable for DHCPv6.
Configuring the Switch
Comments