Unit With Power On Board - Leds - Magma Roben-3TX User Manual

Magma
FIGURE T2-B
Power on board – LEDs
LEDs D6 and D8 are illuminated when power cord is attached to expansion unit. This means the expansion
unit is on standby-mode. The magma device is" switched off" on the electronic interface (but it draws
some power). On standby mode the Magma is not performing its primary function; it is waiting to be
activated by a remote power or remote controller. See picture below.
FIGURE T2-C
see Chapter 4
If the above LEDs are not coming ON, please check the power standby cable ( ) make sure
it is firmly connected to Thunderbolt Interface card power connector (J7).
Roben 3 | Chapter 4 Advanced Technical Information 33