Magma Roben-3TX User Manual page 65

In Windows Control Panel  Device Manager  View by connection
You should see these three PCI-to-PCI bridges. Right click on it and select "Properties", select Hardware Ids
from dropdown list, you should see PCI\Ven_111D
Q: My host computer is having problem linking up with the expansion chassis. I have both interface cards
installed and seated firmly in their corresponding slot; one is installed in the host computer PCIe slot and the
other one in the expansion PCIE slot. Is there something wrong with the Interface card?
A: When using the 01-04973-03, in which comes in pair, one should be set to OFF-host and the other is set to
ON-Exp.
Set the Red Dip switch on the interface card that correctly in order to work. The Red Dip switch
1.
is labeled SW1.
01-04973-03, SW1 when set to ON=EXP should be installed only inside the Magma Expansion
2.
unit.
01-04973-03, SW1 when set to OFF=HOST should be installed inside the host computer.
3.
If the 01-04973-03 cards are not set properly, your computer will not link up with the Magma
4.
expansion.
See photos below:
Roben 3 | Chapter 6 Troubleshooting / FAQ
Magma
65