Table of Contents
Advertisement
[:VOLTage[:DC]]
Parameters
Comments
Example
94 Multimeter Command Reference
CONFigure[:VOLTage[:DC]] [<
resolution
[,<
>|MIN|MAX|DEF]]
specify the range and resolution.
Parameter Name
Parameter Type
range
<
>
resolution
<
>
•
To select a standard measurement range, specify range as the input signal's
maximum expected voltage. The multimeter then selects the correct range to
accept the input.
•
The
AUTO
or
DEFault
option for resolution defaults the integration time to 10 PLC.
DEFault
•
The
and
MIN
MAX
range and resolution:
For range:
= 100mV;
MIN
For resolution:
MIN
selected range.
MAX
selected range. See Table 3-1 on page 70 for valid resolution choices for
each range.
•
To select autorange, specify
range and resolution parameters. In the autorange mode, the multimeter
samples the input signal before each measurement and selects the appropriate
range.
•
To specify a
MIN
or
AUTO
or
DEFault
for range;
CONF:VOLT:DC DEF,MAX
CONF:VOLT:DC AUTO,MAX
prevents the
MIN
or
•
Related Commands:
Making DC Voltage Measurements
CONF:VOLT 0.825,MAX
SAMP:COUN 3
INIT
FETC?
enter statement
range
>|MIN|MAX|DEF|AUTO
selects the DC voltage function and allows you to
Range of Values
numeric
100mV|1V|10V|100V|300V|
MIN|MAX|DEF|AUTO
numeric
resolution|
option for the range parameter enables autorange. The
parameters select the minimum or maximum value for
= 300V.
MAX
selects the best resolution (the smallest value) for the
selects the worst resolution (the largest value) for the
DEFault
for range or do not specify a value for the
MAX
resolution while autoranging, you must specify
CONF:VOLT:DC DEF,MIN
or
CONF:VOLT:DC AUTO,MIN
(you cannot omit the range parameter). This
MAX
resolution from being interpreted as a range setting.
FETCh?
,
INITiate
,
READ?
Function: DC voltage; range selected: 1A;
MAX resolution: 100 A.
Take 3 readings.
Place multimeter in wait-for-trigger state;
store readings in internal memory; trigger
source is IMMediate by default.
Place readings in output buffer.
Enter readings into computer.
Default Units
volts
volts
MIN|MAX|DEF
or
or
Chapter 3
Advertisement
Table of Contents
