Table of Contents
Advertisement
FRESistance:RESolution
Parameters
Comments
FRESistance:RESolution?
Example
Chapter 3
[SENSe:]FRESistance:RESolution <
resistance measurements.
Parameter Name
Parameter Type
resolution
<
>
•
selects the best resolution (the smallest value) for the selected range.
MINimum
selects the worst resolution (the largest value) for the selected
MAXimum
range.
•
You must select a range using
resolution. Also, only specify a resolution when making measurements on a
fixed range. Otherwise, the resolution will change to correspond with the range
selected during autoranging.
•
Specify resolution in the same units as the measurement function.
•
If autoranging is required, set the resolution using the
or select a specific integration time using
•
*RST
Condition:
[SENSe:]FRESistance:RESolution? [MIN|MAX]
numbers to the output buffer:
•
The present resolution selected if
resolution values available on ranges set by the
returned.
•
The resolution with the smallest value (i.e., the best resolution) for the selected
range if
MIN
is specified.
•
The resolution with the largest value (i.e., the worst resolution) for the selected
range if
is specified.
MAX
Query the Resolution
FRES:RES 0.3E-03
FRES:RES?
enter statement
resolution
Range of Values
numeric
resolution
FRESistance:RANGe
FRESistance:NPLCycles
FRES:RES 1m
(1E-03)
or
MIN
MAX
Set resolution to 0.3m.
Query multimeter to return the present
resolution.
Enter value into computer.
Multimeter Command Reference
>
selects the resolution for 4-wire
Default Units
|MIN|MAX
before specifying
or
parameters
MIN
MAX
.
returns one of the following
are not specified. Only the
command are
RANGe
ohms
135
Advertisement
Table of Contents
