Motor Connection - Danfoss mcd-500 Operating Instruction

4 Electrical Installation

4.1.7 Motor Connection

MCD 500 soft starters can be connected to the motor in-line or inside delta (also called three-wire and six-wire connection). The MCD 500 will automatically
detect the motor connection and perform the necessary calculations internally, so it is only necessary to program the motor full load current (par. 1-1).
NB!
For personnel safety, the power terminals on models up to MCD5-0105B are protected by snap-off tabs. When using large cables, it
may be necessary to break off these tabs.
Models which are internally bypassed do not require an external bypass contactor.
4
14
MG.17.K2.02 - VLT ® is a registered Danfoss trademark
MCD 500 Operating Instruction