Frank An Envelope Or Label; Getting Started - Neopost ij25 User Manual

FRANKING
INTRODUCTION
In order to achieve the best impression, your
to print, therefore on bulky or uneven items correct folding of the contents will help
considerably.
It is sometimes unavoidable that your mail will contain staples, paper clips and other
fixings. The machine will accept these, but it is recommended that the fixings are situated
at the bottom of the envelope. This will avoid the risk of damage to your printing head.
In the event that a satisfactory print cannot be achieved due to bulky contents (Max.
8 mm) the envelope should be treated as a packet and a label used.
It is recommended that the
maintaining print quality. In the event that you have power the machine down, please
wait for one minute after performing the last operation before removing the power.

GETTING STARTED

Set the switch on the power supply outlet to the OFF position, connect the power unit to
the power supply outlet and the other end to the D.C. input socket (
the machine.
Now set the switch on the power outlet socket to ON.
When the machine is ready, the following displays will be observed:
WELCOME TO IJ25
PLEASE WAIT . .
If using the machine for the first time, the
WARNING INSPECTION REQD display may be observed,
go to page 24 to add credit to the machine.
To Log On
To unlock the machine, enter the user PIN.
Notes: If using the machine for the first time, the Factory default user PIN is set to 1 2 3 4.
To change or disable the user PIN, please see page 19 (by disabling the user PIN,
the machine will be accessible to all user's).
Enter PIN, e.g. 1 2 3 4
Press:
If an incorrect PIN is entered, check PIN for accuracy and try again.
6
is left powered on at all times. This will assist in
Followed by
.
F r a n k i n g M a c h i n e U s e r ' s G u i d e
requires an even surface on which
) at the back of
LOCKED
09:01 02/12/00
WARNING
INSPECTION REQD
LOCKED
----