Jump-Starting - Seat Leon 2012 Owner's Manual

266 If and when
Sun visor light
– Carefully remove the lamp, using the flat side of a screwdriver,
as shown in the figure
Fig. 178 Removing sun
visor light
Fig. 179 Removing sun
visor light
⇒ f ig.
179.
– Remove the bulb, moving it in the direction of the arrow and
⇒ f ig.
outwards 179.
– Installation is done in the reverse order.

Jump-starting

Jump leads
The jump lead must have a sufficient wire cross section.
If the engine fails to start because of a discharged battery, the battery can
be connected to the battery of another vehicle to start the engine.
Jump leads
Jump leads must comply with standard DIN 72553 (see manufacturer's doc-
umentation). The wire cross section must be at least 25 mm
2
gines and at least 35 mm for diesel engines.
Note
● The vehicles must not touch each other, otherwise electricity could flow
as soon as the positive terminals are connected.
● The discharged battery must be properly connected to the vehicle elec-
trical system.

2
for petrol en-
