Seat Leon 2012 Owner's Manual page 128

126 Lights and visibility
Intermittent wipe
– Move the lever up to position
– Move the control to the left or right to set the length of the
A
intervals. Control to the left: long intervals; control to the right:
short intervals. Four wiper interval stages can be set using
switch .
A
Slow wipe
– Move the lever up to position
Continuous wipe
– Move the lever up to position
Short wipe
– Move the lever down to position
short wipe. The wiper will start to move faster if you keep the
lever pressed down for longer than two seconds.
Wash and wipe automatic system 
– Pull the lever towards the steering wheel - Position
wash function will start immediately and the wipers will start
with a slight delay. The wash and wiper systems will function at
the same time at speeds of over 120 km/h.
– Release the lever. The wipers will keep running for approximate-
ly four seconds.
Heated windscreen in the wiper blade area*
In some countries and with some versions, there is the possibility of heat-
ing the windscreen in the area of the windscreen wiper blades in order to
aid de-icing in the zone. The function is switched on by pressing the heated
rear window key .
.
1
.
2
.
3
to give the windscreen a
4
. The
5
WARNING
● Worn and dirty wiper blades reduce visibility and safety levels while
driving.
● In cold conditions, you should not use the wash / wipe system unless
you have warmed the windscreen with the heating and ventilation sys-
tem. The washer fluid could otherwise freeze on the windscreen and ob-
scure your view of the road.
● Always note the corresponding warnings on ⇒ p age 230.
CAUTION
In icy conditions, always check that the wiper blades are not frozen to the
glass before using the wipers for the first time. If you switch on the wipers
when the wiper blades are frozen to the windscreen, you could damage
both the wiper blades and the wiper motor.
Note
● The windscreen wipers will only work when the ignition is switched on.
● In certain versions of vehicles with alarms, the windscreen wiper will on-
ly work when the ignition is on and the bonnet closed.
● When in use, the wipers do not go as far as the rest position. When the
lever is moved to the 0 position, they move to the rest position.
● The next speed down will automatically be selected if wiper speed
⇒ f ig. 81
or is selected when the vehicle stops. The set speed will be re-
3
sumed when the vehicle starts again
● The windscreen will be wiped again after approximately five seconds
once the "automatic wipe/wash system" has been operated, provided the
vehicle is in transit (drip function). If you activate the wipers less than three
seconds after the drip function, a new wash sequence will begin without the
last wipe. For the "drip" function to work again, you have to turn the ignition
off and then on again.
2
