Seat Leon 2012 Owner's Manual page 251

Raising the vehicle
In order to remove the wheel, the vehicle must be raised
with a jack.
Safety First
Fig. 157 Jack position
points
Fig. 158 Fitting the jack
Operating Instructions
– Locate the jacking point under the door sill closest to the wheel
⇒ f ig.
to be changed 157.
– Place the jack under the jacking point and turn the crank until
the arm of the jack is directly below the vertical rib under the
door sill.
– Align the jack so that the arm of the jack fits around the rib un-
der the door sill and the movable base plate of the jack is flat
⇒ f ig.
on the ground 158.
– Raise the jack until the defective wheel is just clear of the
ground.
Recesses at the front and rear of the door sills mark the jacking points
⇒ f ig.
157. There is only one jacking point for each wheel. Do not fit the jack
anywhere else.
An unstable surface under the jack may cause the vehicle to slip off the
jack. Therefore, the jack must be fitted on solid ground offering good sup-
port. Use a large and stable base, if necessary. On a hard, slippery surface
(such as tiles) use a rubber mat or similar to prevent the jack from slipping.
WARNING
● Take all precautions so that the base of the jack does not slip. Failure
to do so could result in an accident.
● The vehicle can be damaged if the jack is not applied at the correct
jacking points. There is also a risk of injury since the jack can slip off
suddenly if it is not properly engaged.
Practical Tips
If and when 249

Technical Specifications