Fz5-L Series - Omron fh series Hardware Manual

6-4-4

FZ5-L Series

Cable
• Connect the LAN cable with a straight or cross cable.
• Use an STP (shielded twisted-pair) cable of category 5, 5e, or higher. Applicable EtherNet/IP com-
munications cables and connectors vary depending on the used baud rate.
• For 100Base-TX and 10Base-T, use an STP (shielded twisted-pair) cable of category 5 or higher. You
can use either a straight or cross cable.
• For 1000Base-T, use an STP (shielded twistedpair) cable (double shielding with aluminium tape and
braiding) of category 5e or higher.
I/O Connector
• Electrical specifications: Conforming to IEEE 802.3 standards. Use RJ45 8-pin Modular Connector
(conforming to ISO 8877).
• When selecting a connector, confirm that it is applicable to the cable that will be used. Confirm the
following items: Conductor size, conductor type (solid wire or twisted wire), number of twisted pairs (2
or 4), outer diameter, etc.
Pin Layout
10Base-T and 100Base-TX
1000Base-T
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
Connector pin Signal name
1 Transmission data +
2 Transmission data -
3 Reception data +
4 Not used.
5 Not used.
6 Reception data -
7 Not used.
8 Not used.
Connector pin Signal name
1 Communication data DA +
2 Communication data DA -
3 Communication data DB +
4 Communication data DC +
5 Communication data DC -
6 Communication data DB -
7 Communication data DD +
8 Communication data DD -
6 I/O Interface
Abbr. Signal direction
TD + Output
TD - Output
RD + Input
---
---
RD - Input
---
---
Abbr. Signal direction
BI_DA + Input/output
BI_DA - Input/output
BI_DB + Input/output
BI_DC + Input/output
BI_DC - Input/output
BI_DB - Input/output
BI_DD + Input/output
BI_DD - Input/output
6
---
---
---
---
6 - 55